Tabla De Contenido; Safety Instructions - Emerson AIRA ECO Manual Del Usuario

Section
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
1. Unpacking Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
2. Electrical Requirements
3. Ceiling Fan Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-7
4. How to Hang Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . .8-10
5. How to Wire Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . .10-11
6. Installation of the Ceiling Cover . . . . . . . . . . . . . . . . . . . . . . .12
7. Installation of the Fan Blades . . . . . . . . . . . . . . . . . . . . . . . . .13
8. Installation of Downlight Assembly . . . . . . . . . . . . . . . . . .14-16
9. Optional Installation of No-Light Cover Plate . . . . . . . . . . . . .17
10. Wall Control Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . .18
READ AND SAVE THESE INSTRUCTIONS
WARNING
!
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a. Use this unit only in a manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
b. Before servicing or cleaning unit, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a warning device,
such as a tag, to the service panel.
1. Read your owner's manual carefully and keep it for future
reference.
2. Be careful of the fan and blades when cleaning, painting,
or working near the fan. Always turn off the power to the
ceiling fan before servicing.
3. Do not put anything into the fan blades while they are
turning.
4. Do not operate reversing switch until fan blades have
come to a complete stop.
Additional Safety Instructions for Installation
1. To avoid possible shock, be sure electricity is turned off
at the fuse box before wiring, and do not operate fan
without blades.
2. All wiring must be in accordance with the National
Electrical Code "ANSI/NFPA 70-2014" and Local
Electrical Codes. Use the National Electrical Code if
Local Codes do not exist. The ceiling fan must be
grounded as a precaution against possible electrical
shock. Electrical installation should be made or
approved by a licensed electrician.
DATE CODE:
The date code of this fan may be found on the box, stamped in ink on a white label. You should record
this data above and keep it in a safe place for future use.
Table of Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Safety Instructions

Page Section
11. Wall Control Installation . . . . . . . . . . . . . . . . . . . . . . . . . .19-22
12. Programming Fan Control . . . . . . . . . . . . . . . . . . . . . . . . . .23
13. Using Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
14. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
15. Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
16. Instruction to the User . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
17. Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26-27
18. Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
Ceiling Fan Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . .29
Spanish . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31
French . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .61
3. The outlet box and joist must be securely mounted and
capable of reliably supporting at least 50 pounds. Use
only U.L. outlet boxes listed as "Acceptable for Fan
Support of 22.7 kg. (50 lbs.) or less", and use the
mounting screws provided with the outlet box.
Most outlet boxes commonly used for support of light
fixtures are not acceptable for fan support and may need
to be replaced. Consult a qualified electrician if in doubt.
4. The downrod furnished with the fan provides the
minimum recommended floor to fan blade clearance for
an 8 foot ceiling.
5. The fan must be mounted with the fan blades at least
7 feet from the floor to prevent accidental contact with
the fan blades.
6. Follow the recommended instructions for the proper
method of wiring your ceiling fan. If you do not know
enough about electrical wiring, have your fan installed by
a licensed electrician.
WARNING: To reduce the risk of electrical shock, this fan
must be installed with an isolating wall control/switch.
WARNING: To avoid fire, shock or injury, do not use an
Emerson or any other brand of control not specifically
approved for this fan.
WARNING: This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use this product by Emerson
Electric Co. Substitution of parts or accessories not
designated for use with this product by Emerson could
result in personal injury or property damage.
WARNING: To reduce the risk of personal injury, do not
bend the blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
NOTE: All setscrews must be checked and re-tightened
where necessary before installation.
2
Page
E.T.L. Model No.: CF985