GLOBBER ELITE DELUXE Serie Manual Del Usuario página 4

Keep the instructions for future.
NF-EN-71
Warning! Not suitable for children under 36 months, unstable
base, fall hazard. Warning! Protective equipment should be worn.
Not to be used in traffic. 50 kg max.
Remove the scooter and all the parts from the box. Set out all the parts and read
the assembly instructions prior to use. Keep the packaging until assembly is
complete.
Warning! T-bar folding and unfolding shall be done by an adult. The scooter can
only be used by children once the adjustment is done.
ELITE DELUXE LIGHTS / ELITE PRIME:
WARNING! This product is powered by two built-in CR2032 lithium batteries.
Due to their small size, lithium batteries can easily be swallowed by children.
Ingestion of such batteries has been known to cause death.
Replace the electronic module when the batteries are exhausted.
General instructions
This toy must be assembled by a responsible adult. Prior to use, make sure
that the toy has been assembled properly. Remove all the parts which are not
necessary for play before giving the toy to your child. The toy should be used with
caution since skill is required to avoid falls or collisions causing injury to the user
or third parties.
To use with suitable protective equipment, including a helmet, shoes, elbow, wrist
and knee protectors. Teach the child how to use it safely and responsibly.
4
Directions:
- T he scooter can be dangerous and can cause traffic accidents when used on
public highways. Don't use on the public roads. It is best used on a flat, clean
surface, free of gravel and grease. Avoid bumps and drainage grates that may
cause an accident.
- T he scooter does not include any headlights or lights. It is therefore not suited for
use at night or during periods when visibility is limited.
- A lways use under adult supervision.
- Do not allow more than one child to ride the scooter at the same time.
- Do not use on wet days, or on wet ground.
Before and after use:
- Make sure that all locking mechanisms are securely locked:
- C heck the height of the steering system, and make sure the nuts are tightened
and that the handlebars and the front wheel are perpendicular.
- T he minimum height of T-bar has to be locked at the lowest position by switching
the bullet into the lowest slot.
- C heck all of the connection elements: the brake, the steering column's quick
release system and the wheel axles must be adjusted correctly and not damaged.
- Also check the tyre wear.
SCOOTER ASSEMBLY (See page 2)
Insert the handle bar (T-bar) tube into the hole at the front of the main board
between the two front wheels while paying attention to the direction of insertion.
Ensure the spring loaded button pops out and locks the bar in place properly.
ELITE is provided with an adjustable T-bar which can be adapted to the child's
height (4 positions). The spring loaded button shall be in the hole when adjusting
the T-bar height.
Make sure that for the lowest position of T-bar, the button is locked into the lowest
hole. Loosen the quick release clamp of the T-bar when adjusting. Tighten the
quick release clamp to secure T-bar after adjustment.