ESAB EMP 215ic Instrucciones De Uso página 26

6 CONTROL PANEL
2T, Trigger On/OFF
4T, Trigger Hold/Lock
Amps
Arc force On stick
welding-increasing amps
when the arc length is
shortened to reduce or
eliminate the freezing of the
stick electrode in the weld
puddle
Downslope Sloping the
current down over a period
of time at the end of the
weld cycle
Hot start The increase of
amps when striking the
electrode to reduce sticking
Inductance The addition of
inductance into the arc
characteristics to stabilize
the arc and reduce spatter
when in the short circuit
process
Memory, able to save
welding programs for a
specific application
Stick electrode choice
Upslope, Sloping the
current up over a period of
time at the beginning of the
weld cycle
0463 408 001
Burnback Adjusting the time
when the voltage stays on
after the wire feed is stopped
to keep the wire from freezing
in the weld puddle
User manual on main menu
Plate thickness at sMIG
mode
Trim bar Changing the weld
bead profile from flat to convex
or flat to concave
Advanced Settings
Basic Settings
Diagnostics
Language selection
Unit of Measure
Bead profile, concave
- 26 - © ESAB AB 2016