Installation; Location - ESAB EMP 215ic Instrucciones De Uso

4 INSTALLATION

Wire feed speed
Wire diameter
Mild steel solid wire
Stainless steel solid wire
Flux cored wire
Aluminium
Bobbin size
Dimensions l×w×h
Weight
Operating temperature
Enclosure class
Application classification
Duty cycle
The duty cycle refers to the time as a percentage of a ten-minute period that you can weld at
a certain current without overheating. The duty cycle is valid for 40°C / 104°F.
For more information se section "Duty cycle" in the OPERATION chapter.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration
by solid objects or water.
Equipment marked IP 23S is intended for indoor and outdoor use; however, should not be
operated in precipitation.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
4 INSTALLATION
The installation must be carried out by a professional.
CAUTION!
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the user's responsibility to take adequate
precautions.
4.1

Location

Position the power source so that its cooling air inlets and outlets are not obstructed.
0463 408 001
1.5-12 m/min (62-475
inch/min)
0.6 mm (.023") - 1.0 mm
(.040")
0.8 mm (.030") - 1.0 mm
(.040")
0.8 mm (.030") - 1.1 mm
(.045")
0.8 mm (.030") - 1.2 mm
(.045")
Ø 100-200 mm (4"- 8")
548 mm (23.0") × 229 mm
(9.0") × 406 mm (16.0")
18.2 kg (40 lbs)
-10 to +40 °C (-14 to +104 °F) -10 to +40 °C (-14 to +104 °F)
IP23S
- 11 -
EMP 215ic
1.5-12 m/min (62-475
inch/min)
0.6 mm (.023") - 1.0 mm
(.040")
0.9 mm (.035") - 1.0 mm
(.040")
0.8 mm (.030") - 1.1 mm
(.045")
0.8 mm (.030") - 1.2 mm
(.045")
Ø 100-200 mm (4"- 8")
548 mm (23.0") × 229 mm
(9.0") × 406 mm (16.0")
18.2 kg (40 lbs
IP23S
© ESAB AB 2016