Torch And Liner Maintenance - ESAB EMP 215ic Instrucciones De Uso

7 MAINTENANCE
Power source and wire feeder cleaning procedure
NOTE!
Always were safety gloves and spectacle during cleaning.
1. Disconnect the power source from the input power socket.
2. Open the lid and release the tension from the pressure roller by turning the tension
screw (1) counter-clockwise and then pull it toward you.
3. Remove the wire and the wire bobbin.
4. Remove the torch and use a low pressure airline, taking care not to let the wire
consumable unravel, to clean the power source interior and power source air inlet and
outlet.
5. Inspect if the inlet wire guide (4), outlet wire outlet (2) or the feeder roller (3) are worn
and need replacement. See appendix WEAR PARTS for ordering numbers of parts.
6. Remove and clean the feeder roller with a soft brush. Clean the pressure roller attached
to the wire feeder mechanism with a soft brush.
7.3

Torch and liner maintenance

Torch and liner cleaning procedure
1. Disconnect the power source from the input power socket.
2. Open the lid and release the tension from the pressure roller by turning the tension
screw (1) counter-clockwise and then pull it toward you.
3. Remove the wire and the wire bobbin.
4. Remove the torch from the power source.
5. Remove the liner from the torch and inspect it. Clean the liner by blowing compressed
air (max 5 bar) through the end of the liner that was mounted closest to the power
source.
6. Re-install the liner.
0463 408 001 - 29 - © ESAB AB 2016