Security Menu; Configure Security; Access Rights Management - Hach ORBISPHERE 410 Manual Básico Del Usuario

1. Push OK when the message to change the default login credentials shows on the display. Push
OK.
2. Push the padlock icon on the header bar of the top of the display for more than 2 seconds to
unlock the touch screen.
The login window shows on the display.
3. Enter the default user login credentials: "1007" for the ID and "1234" for the password. Push OK.
4. Push OK when the message to change the defautl loggin credentials shows on the display.
The users table, which is used to manage the registered users, shows on the display.
5. Push on the row of the default user. The user modifcation window shows.
6. Change the Name, ID, Password and security level values. Push OK to save the values.
7. Complete the table with the necessary users or push OK to leave.
Note: If the instrument security is enabled and the login credentials are not known, contact Hach Service support
with the recovery code to get the login credentials. The recovery code shows on the login window. The supplied
login credentials expire in one day. Make sure to change the login credential with known values.
Section 7 Operation

7.1 Security menu

Note: When the instrument is started for the first time, security is enabled. Refer to
recommended that each user be entered into the system and given appropriate access rights as soon as possible
to avoid any unauthorized access.

7.1.1 Configure security

Define access levels for all users . This requires a user access level 4.
1. Select Configuration from the Security menu.
Option
Access rights
Max session time
User action logging When enabled every action from a logged on user is recorded in a user log file.
User action log file

7.1.2 Access rights management

Each user has a unique ID and password used to:
• Allow or deny a user to perform specific actions
• To trace all actions by "ID" in a log file
Once the ID and password are entered the user is allowed to perform actions according to the
"Access level" that has been attributed by the Manager:
Access level Typical rights
0 View parameters, change views
1 + Start / Stop measurements
2 + Calibration
3 + Modify parameters
4 + Modify table "User Access level" + Enable/Disable "Access right"
Description
When enabled only registered users can access the menus. When disabled (default)
all menus are freely accessible and no ID is recorded against any action in the log file.
The user is logged out automatically when the time limit is reached.
The log file is a rolling buffer recording recent actions. Press Clear to empty the log
file.
Start up on page 14. It is highly
English 15