Switch On/Off; Acoustic Warning Signal; Service And Maintenance - Festool HKC 55 EB Manual De Instrucciones Original

English
power tool when it is in perfect working or­
der.
– Always secure the workpiece in such a way
that it cannot move during machining.
– When working, always hold the power tool
with both hands on the handles [1-1]. This
reduces the risk of injury and is a prerequi­
site for precise work.
Always push the saw forwards [8-9], and
–
never towards yourself.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
prevent plastic materials from melting dur­
ing cutting.
Make sure that the rotary knob [1-12] is
–
tightened before starting work.
8.1

Switch on/off

► Slide switch-on lock [1-2] upwards.
► Press the ON/OFF switch [1-7].
Press = ON
Release = OFF
8.2

Acoustic warning signal

Acoustic warning signals sound and the power
tool switches off in the following operating
states:
Battery flat or power tool overloaded:
peep
► Change the battery
► Reducing the load on the power tool
8.3 Sawing along the scribe mark
The cut indicators display the cutting sequence
without a guide rail:
0° cuts: [7-1]
45° cuts: [7-2]
8.4 Cutting sections
Position the saw with the front part of the saw
table on the workpiece, switch on saw and push
forward in cutting direction.
8.5 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must always be followed when
plunge cutting:
– Always position saw with the rear edge of
the saw table against a fixed stop.
– When working with the guide rail, place the
saw against the kickback stop FS-RSP (ac­
cessories) clamped to the guide rail.
22
Caution!Danger of crushing!
Always keep a firm grip on the machine
with your free hand when adjusting plunge cuts.
Never position your fingers behind or below the
saw blade.
Procedure
► Adjusting cutting depth, see section
► Press lever [8-1] down.
Sawing unit swivels upwards to plunge-cut po­
sition.
► Hold retractor lever [8-2] downwards as far
as stop.
Pendulum guard [8-4] opens and the saw blade
is exposed.
► Position saw on workpiece and position
against a stop (kickback stop).
► Switch on saw.
► Slowly press down saw to the set cutting
depth until the saw engages, release re­
tractor lever [8-2] and push forward in cut­
ting direction [8-9].
The notch [8-3] indicates the absolute rear cut­
ting point of the saw blade (diameter 160 mm)
when using the saw at maximum cutting depth
with the guide rail.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festool.co.uk/service
5
3
2
1
Cleaning the machine regularly, espe­
cially the adjusting devices and guides, is
an important safety factor.
7.2 .