Migatronic SIGMA2 PULSE Guía Rápida página 3

Selecting welding program
Press and hold (14A) to open for selecting welding program. A "P" is displayed in (12) and a figure
is displayed in (13), referring to the list of welding programs (enclosure 50113742). The active
welding program is marked with "•". Select welding program by turning (14). Press (14A) briefly to
accept choice.
Recall factory settings
After long press on (14A), press and hold (20) until the list of welding programs is closed.
Setting welding process
Press and hold (15A) to open for setting the welding process. Choose parameter by turning (14). Set the chosen
value by turning (15). To close this function, press (15A) briefly.
MIG parameters
Set welding current (A)
* F33, F34, F35 and F36 are only adjustable when a synergic MIG welding programme is chosen.
* F32 (softstart) is off when "----" is displayed.
* F33 (hotstart) is to be set in % of the set welding current.
* F52 Cable compensation (calibration of resistance in welding hose)
* F71 Reduction of voltage trim (0-50%)
* F72 Reduction of current setting (0-25%)
DUO Plus™ parameters (not manual)
When (18) is activated, the operator is also
allowed access to the following DUO Plus™
parameters:
A
F20
DUO Plus TM efficiency rate 0-50%
of set welding current (A)
Set
welding
current
(A)
t
F21
Pause time
DUO Plus TM
time (s) (s)
F31 Pre-gas
F32 Softstart
F33 Hotstart
F34 Hotstart time
F35 Slope
F36 Stop amp
F37 Burn-Back
F38 Post-gas
F39 Spot time
F40 Stop Amp time
MMA (elektrode) parameters
When the MMA welding programme is
chosen, the operator is allowed access to
the following parameters only:
A
F12
F11 Hotstart
F13
t
F12 Hotstart time (0,5 sec.)
F13 Arc force
F11
%
Short circuit
Set welding
current (A)
t
50113715 G1
QUICKGUIDE SIGMA
(0,2 sec.)
(1,0 m/min.)
(25%)
(0,5 sec.)
(0,2 sec.)
(50 %)
(5 (0-30))
(3,0 sec.)
(0,0 sec.)
(0,0 sec.)
(25%)
(25%)
Figure 1
PULSE
2
UK