Publicidad
Idiomas disponibles
Idiomas disponibles
2. Remove the rear sill trim panel (1) by unsnapping the four
retainers.
3. Remove the drain plug located at the bottom left hand
side of the spare tire compartment.
4. Place the 4 -wire connector of the trailer harness through
the drain hole (1) and seat the channel of the grommet (2)
in the hole. When the grommet is properly installed it will
not pull out of the hole easily.
5. Pull back the bottom of the driver's side kick panel, there
will be a wire harness with a 4 -wire connector at the end.
The trailer harness (1) will be plugged into this connector.
6. Route the rest of harness and connect the 4 -wire connec-
tor to the vehicle connector.
7. Attach harness with adhesive pad (3) to vehicle.
Trailer Hitch Draw Bar Package
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINT-
ED EXACTLY AS SHOWN ON
8.5 x 11 WHITE 16 POUND NON-
BOND RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EX-
CLUDING TEMPLATES.
TO BE UNITIZED IN AC-
CORDANCE WITH GMSPO
SPECIFICATIONS.
REVISION
AUTH
8. Connect the trailer harness (2) to the harness pigtail (1)
that is already mounted on the hitch.
9. ,QVWDOO VSDUH WLUH UHDU WULP SDQHO ORDG ÀRRU DQG VWRUDJH
compartment cover. Note: Always unplug your trailer har-
ness from the vehicle trailer harness before backing trailer
into water.
REV 05AU12
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Trailer Hitch Draw Bar Package
19244244
PART NO.
Grand Pointe Dr., Grand Blanc, MI 48439 6200
19244244
SHEET
3
SHEET
3
9
OF
9
OF
Publicidad
