Sauder 412922 Manual De Instrucciones página 18

Step 13
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (L) and lay it over your unit.
Make equal margins along the short edges of the BACK (F).
å
The BACK should be even with the TOP (E) and will overhang
the BOTTOM (G) slightly. Push on opposite corners of your
unit if needed to make it "square".
Fasten the BACK (L) to your unit using the NAILS (LLL).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS
(C and D)
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
Th BACK will overhang
the BOTTOM slightly.
Page 18
.
These holes
must be here.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up over
the UPRIGHTS (C and D).
L
412922
LLL
NAIL
(60 used in this step)
Th BACK should be even
with the TOP.
www.sauder.com/services
E