Sauder 412922 Manual De Instrucciones página 21

Step 16
Carefully stand your unit upright.
å
Fasten the FLIP TOP (F) to the SMALL BACK (J). Use the screws in the HINGES.
å
Refer to the enlarged diagram to identify the parts on the SW HINGES.
å
The FLIP TOP may need some adjustments. Follow the text below to make needed adjustments.
å
FLIP TOP ADJUSTMENTS:
å
To adjust the FLIP TOP in or out (depth), turn the adjusting screw in or out.
å
To adjust the FLIP TOP side to side (horizontal), loosen all horizontal adjustment screws. Move the FLIP TOP side to side
å
so the edges are even with the TOP. Tighten the screws after making adjustments.
To adjust the FLIP TOP up or down (vertical), loosen the mounting screw one turn and move the FLIP TOP up or down as
å
needed. Tighten the mounting screw after making adjustments.
Pro Tip: Lift with your
legs. And, you know,
your arms.
NOTE
:
The FLIP-TOP will
sit slightly higher
than the TOP.
www.sauder.com/services
Adjusting screw (depth)
Mounting screw
(vertical)
412922
VV
(horizontal adjustment screws)
F
J
Page 21