Audio Recording; Technical Data - Siemens SMV11 Instrucciones De Instalación

4.2 Recording of help messages (Fig.3)
1 - Select recording help messages through engineer
menu.
2 - Select with the selection wheel the position of the
help message (Q Fig.3) to be recorded (1 to 4).
3 - Press record button and speak the message
towards the microphone.
4 - Release the record button at the end of the
message.
5 - Check with play button if the message is OK.
Loudspeaker switch must be closed.
6 - Record next message in the same way.
7 - At the end of the recording the loudspeaker must
be disconnected by opening the loudspeaker
switch.
Help messages can have a maximum length of 6.4
seconds each.
Help 1: Acknowledge of alarm transmission, played
after alarm transmission.
e.g. „To acknowledge the alarm press the
key on your phone".
Help 2: Text for audio recording, played before
playback of audio recording.
e.g. „This is a recorded alarm audio signal".
Help 3: Use of audio verification commands, played
before switching to direct audio verification.
e.g. „With the key
listen-in to speak".
Help 4: Not used.

4.3 Audio recording

If the SMV 11 is used with an audio circuit board (e.g.
WMA 11) the SMV 11 records the audio signal during
the first 6 seconds after an alarm.

5. Technical data

Supply
Power consumption quiescent
Power consumption by challenge
Operating temperature
Dimensions in mm
Weight
The right to make technical changes to the described equipment without prior
notice is reserved.
and you change from
From main circuit board
3 mA
25 mA
0 to +40 °C
H 60 x L 106 x D 26
60g