Important - HYTROL TL Manual De Instalacion Y Mantenimiento Con Informacion Sobre Seguridad Y Lista De Partes

Tabla de contenido

Publicidad

IMPORTANT: When belt tracking adjustments are
made, they should be minor (1/16 in. at a time on idlers,
etc., should be sufficient.).
Give the belt adequate time to react to the adjustments.
It may take several complete revolutions around the
conveyor for the belt to begin tracking properly on long,
slow conveyor lines.
A) Stand at tail pulley looking toward drive and note
what direction belt is traveling.
B ) H aving observed belt and determined tracking
problem, follow procedures in "How to Steer The Belt",
See Figure 20A.
HOW TO STEER THE BELT
Condition 1. . .When the belt is running in the
direction (FLOW) with the arrow, but tracking (drifting)
towards Side "X", move the Snub Idler nearest the
INFEED end of Side "Y" towards the DISCHARGE end
of the conveyor.
Condition 2. . . When the belt is running in the
direction (FLOW) with the arrow, but tracking (drifting)
towards Side "Y", move the Snub Idler nearest the
INFEED end of Side "X" towards the DISCHARGE end
of the conveyor.
If Belt Direction (FLOW) is reversed, all the above
conditions will remain the same as in Figure 20A,
except you are now viewing the conveyor from
the opposite end.
If belt continues to track improperly, re-check all items
c ove red in " P re - Tracking Inspection" and make
corrections as necessary.
FIGURE 20A
N OT E : In all conditions, you are viewing the
Conveyor Belt from the INFEED end. All corrections
will be made from the INFEED end of conveyor.
20
IMPORTANTE: Cuando se hagan ajustes a la banda
deberán hacerse lo menor posible (1/16" a la vez en los
rodillos de retorno, etc., será suficiente).
Dele a la banda el tiempo adecuado para que se ajuste. En
transportadores largos y lentos, tal vez tomará varias vueltas
antes de que quede ajustado.
A) Párese en la polea de retorno y observe hacia que
dirección la banda corre.
B) Despues de haber observado la banda y determinado el
ajuste, siga los procedimientos en "Como Dirigir la Banda",
Vea la figura 20A.
COMO DIRIGIR LA BANDA
Condición 1. . .Cuando la banda está corriendo en
dirección de la flecha (FLUJO), pero se desvia hacia el LADO
"X", mueva el Rodillo de Alineación más cercano del extremo
de CARGA del LADO "Y" hacia el extremo de DESCARGA del
transportador.
Condición 2. . . Cuando la banda está corriendo en
dirección de la flecha (FLUJO) pero se desvia hacia el LADO
"Y", mueva el Rodillo de Alineación mas cercano al extremo
de CARGA del LADO "X" hacia el extremo de DESCARGA
del transportador.
Sí la banda corre en reversa del FLUJO, todas las condiciones
serán las mismas (Figura 20A), exceptuando que
ahora usted está viendo el transportador por el
lado opuesto.
Sí la banda continua estando mal alineada entonces revise
todos los objetivos de la sección "Inspección Pre-Alineación" y
haga las correcciones necesarias.
NOTA: En todas las condiciones, el transportador se
o b s e rvará desde el punto de CARGA. Todas las
correciones serán hechas desde este mismo punto.

Publicidad

Tabla de contenido
loading

Tabla de contenido