Horizon Global 24991 Instrucciones De Instalación página 4

1. Remove (2) plastic underbody panels – using a flat head screwdriver, remove (5) plastic push pin rivets and loosen (2) threaded fasteners from the
driver's side panel located near wheel well area. Remove (4) push pin rivets and loosen (1) threaded fastener from the passenger's side panel.
2a. Remove lower fascia - by hand, remove (6) retaining clips, (3 per side), from underside of fascia, that connect the lower fascia to upper fascia, located
at the outer ends of fascia. NOTE: Two clips are behind the aluminum bumper beam. See Figure 2.
©2019 Horizon Global™ Corp - Printed in Mexico Sheet 4 of 36 24991NP 9-19-19 Rev. A