Hilti DD-400E Manual De Instrucciones página 13

9.4 Mounting the carriage on the rail
1
3
2
9.6 Adjusting the rail angle
2
4
3
1
9.8 Fitting the bracing spindle and taper
5
6
4
1
2
3
9.10 Fitting the handwheel
1
3
2
4
Printed: 07.07.2013 | Doc-Nr: PUB / 5069604 / 000 / 00
1. Carriage
2. Rail
3. Feed movement locking mecha-
nism
The feed movement locking mecha-
nism must face the direction of drilling.
Note: Always keep the feed move-
ment locking mechanism in the closed
position when the carriage is not in
use!
1. Baseplate
2. Baseplate taper for angular drilling
3. Clamping screw
4. Wrench
Secure the column (guide rail) to pre-
vent it from falling when the clamping
screw is released.
1. Rail
2. Eccentric pin
3. Wrench
4. Taper
5. Spindle
6. Locknut
1. Carriage
2. Connecting boss
3. Handwheel
4. Clamping screw
The handwheel can be fitted on either
side of the carriage.
9.5 Fitting the end stop (clamping piece) on the rail
1 2 3 4
9.7 Extending the guide rail
2
4
3
5
1
9.9 Mounting the motor unit on the carriage
2
4
1
9.11 Fitting a core bit
5
1
4
2
3
1. Rail
2. Steel bar
2. Engaging teeth
4. Clamping screw
The use of an end stop is mandatory
for drilling overhead and on walls.
1. Rail
2. Rail extension
3. Taper
4. Eccentric pins (2)
5. Wrench
1. Motor unit
2. Motor unit mount
3. Carriage
4. Mounting surface
5. Eccentric clamping pin
6. Wrench
3
– Supply cord support
5
– Water hose support
Caution:
6
– Do not pinch the supply cord!
– Ensure that the baseplate and guide
rail are secured rigidly before moun-
ting the motor unit!
Removing the motor unit: Hold the
motor to prevent it from falling when
the eccentric clamping pin is pulled
out.
1. Chuck
2. Connection end
3. Core bit
4. Locking sleeve
5. Motor unit
13