Fastening The Seatbelt Of Your Child - CYBEX SOLUTION X-FIX Manual De Instrucciones

FASTENING THE SEATBELT OF YOUR CHILD

Put your child in the child seat. Pull out the three-point belt and lead it in front of
your child to the belt buckle (l).
Warning! Never twist the belt!
Put the belt guide (m) into the belt buckle (l). If you hear a clicking sound it is
securely locked.
Put the lap belt (n) in the bottom belt guides (k) of the child seat. Now pull the
lap belt (n) tight by pulling the diagonal belt (f) until there is no slack. The tighter
the belt the better it can protect from injuries. The diagonal belt and lap belt
should both be inserted in the bottom belt guide at the side of the belt buckle.
Warning! The belt buckle of the car seat (l) must under no circumstances
reach into the bottom belt guide (k). If the belt strap is too long, the child
seat is not suitable for this vehicle.
The lap belt (n) should be placed in the bottom belt guides (k) on both sides of
the seat (d).
Note! Teach your child from the beginning to always pay attention to a tight belt
and that it should pull the belt tight by itself if necessary.
Warning! The lap belt must, on both sides, run as low across the groin
of your child as possible in order to take optimal effect in case of an
accident.
Now lead the diagonal belt (f) through the upper red belt guide (g) in the
shoulder rest (e) until it is inside the belt guide.
Please make sure that the diagonal belt (f) runs between the outer edge of
the shoulder and your child's neck. If necessary, adjust the running of the belt
by adjusting the height of the headrest. The height of the headrest can still be
adjusted in the car.
17