Sauder 411614 Instrucciones De Montaje página 7

4
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the hole of the adjoining part while locking the
FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
 Fasten the SHELF (F) and LOWER SHELF (G) to the LEFT END (B). Tighten four TWIST-LOCK
 Fasten the LEFT MOLDING (P) to the LEFT END (B). Use two BLACK 1-7/8" FLAT HEAD SCREWS (HH).
Finished
edge
B
G
Unfi nished
surface
®
FASTENER (Refer to the enlarged diagram.)
www.sauder.com/services
BLACK 1-7/8" FLAT HEAD SCREW
(2 used in this step)
Finished
surface
P
F
Unfi nished
surface
Curved
edge
HH
®
FASTENERS.
411614