Aerial Feed; Lcn Function - Televes DTR-728701 Instrucciones De Uso

User Manual
9.3.- Antenna Feed
If you are using an "active" aerial (with an amplifier included), you should
enable this option in order to feed the amplifier with 5 V / 100 mA. The feed
is done through the same coaxial cable connected to the ANT IN entry port
of the receiver.
To enable or disable this option use the -
or "On".
To leave the menu, press the EXIT button.
Note: If there is no amplifier you must select the NO option, otherwise you
may damage the receiver.

9.4.- LCN Function

This option allows the user to enable or disable the channel organization
mode defined by the operator.
To enable or disable this option use the -
or "On".
To leave the menu, press the EXIT button.
/ + buttons to select "Off"
/ + buttons to select "Off"
51
"DTR-728701"