User Manual
5.- First Installation
Once you have installed the DTR 728701 receiver, switch it on using the
switch on the back panel.
The first time the receiver is switched on, it will show a guided installation
window. In order to configure the parameters for this window, follow the
instructions below:
Select the Region of location, using the -
The available countries are: Australia, Austria, Czech, Denmark, Dubai,
Finland, France, Germany, Greece, The Netherlands, Italy, Portugal,
Russia, Spain, Sweden, Switzerland, United Kingdom and Vietnam.
You can also press the OK button and select the countries using buttons
PR+ or PR- on the pop-up menu. Press the OK button to confirm.
Press the PR- button.
Select the desired language for the OSD, using the -
The available languages are: English, Danks, Français, Deutsch, Italian,
Português, Español and Svenska.
You can also press the OK button and select a language, using the PR+
or PR- buttons on the pop-up menu. Press the OK button to confirm.
Press the PR- button.
Using the -
or
channel ordering (LCN).
You can also press the OK button and select one of the options using
the PR+ or PR- buttons on the pop-up menu. Press the OK button to
confirm.
Press the PR- button.
Using the -
or
+
power to any possible previously installed aerial amplifiers.
You can also press the OK button and select one of the options using
the PR+ or PR- buttons on the pop-up menu. Press the OK button to
confirm.
If there is no active aerial, you must select the option "Off", otherwise
the receiver may be damaged.
Finally, place the cursor on the "OK" option and press the OK button to
start the search.
The receiver will carry out a search over its whole input frequency band.
Once the search has ended, the receiver will show the first of the channels
on the list.
The process may be halted at any moment by pressing the MENU button.
or
+
buttons, enable (ON) or disable (OFF) automatic
buttons, enable (ON) or disable (OFF) the antenna
buttons.
+
or
buttons.
+
39
"DTR-728701"