Blowing Function; Interrupting Operation; Maintenance And Care - Kärcher WD 1 Manual Del Usuario

Ocultar thumbs Ver también para WD 1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Wet vacuum cleaning
WARNING
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float closes
the suction opening, and the appliance
works at a higher speed. Switch off the ap-
pliance immediately, and empty the con-
tainer.
 Pull a foam filter over the filter basket for
wet vacuum cleaning.
Note: Ensure firm seating of the foam filter.

Blowing function

Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
 Connect the suction hose to the blower
connection, this will activate the blower
function.

Interrupting operation

 Turn off the appliance.
Finish operation
 Turn off the appliance and disconnect
the mains plug.
Empty the container
Illustration
See page 33.
 Remove the appliance head and empty
the reservoir.
Storing the appliance
Illustration
See page 33.
 Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.

Maintenance and care

DANGER
Turn off the appliance and re-
move the mains plug prior to any
care and maintenance work.
Repair works may only be per-
formed by the authorised cus-
tomer service.
WARNING
Do not use abrasives, glass or
universal cleaners! Never im-
merse the appliance in water.
 Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
 If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
Illustration
See page 33.
 Only clean the foam filter under running
water; do not wipe or brush. Let it dry
completely prior to installation.
Troubleshooting
Decreasing cleaning power
If the cleaning power of the appliance dete-
riorates please check the following:
Illustration
 Accessories, suction hose or suction
pipes are clogged, please remove the
obstruction using a stick.
Illustration
 Filter bag is full, install new filter bag.
Illustration
See page 33.
 Clean the foam filter under running wa-
ter; let it dry before reinserting it.
 Filter bag is soiled, tap filter bag.
– 9
EN
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido