KTM 64112955044 Instrucciones De Instalación página 12

- Assemble the individual components that belong together.
NOTE
Compression damping side: Cartridge with additional oil holes ,
fork shoe marked L.
Rebound damping side: Cartridge without additional oil holes, fork
shoe marked R.
- Slide the cartridge into the inner fork tube.
- Unclamp the fork leg with the fork shoe.
NOTE
Use soft jaws.
- Mount cartridge screw with the washer and tighten to 25 Nm.
- Unclamp the fork leg.
- Clamp the left fork leg vertically.
NOTE
Use soft jaws.
- Fill with the fork oil.
Fork oil per fork leg = 470 ml of fork oil (SAE 4) (48601166S1)
NOTE
After approx. half the oil capacity has been fi lled, close the screw
cap of the outer fork tube, unclamp the fork and bounce a number
of times so that the cartridge fi lls with oil. Then add the remaining
amount.
Use only oils that comply with the specifi ed standards (see
specifi cations on the container) and that have the correspond-
ing properties.
- Clamp the fork leg in the area of the upper triple clamp (distance
= 25 mm).
Clamping block T612S
- Grease the O-ring of the screw cap (lubricant T158)
- Tighten the screw cap with 40 Nm.
- Unclamp the fork leg.
12