Publicidad
Idiomas disponibles
Idiomas disponibles
All work marked with this symbol requires specialist knowledge and technical understanding.
In the interest of your own safety, have these jobs performed by an authorized KTM workshop.
There, your motorcycle will be optimally cared for by specially trained experts using the auxiliary tools required.
Scope of supply
1x low chassis kit
2x bushing
2x spacer ring
1x sticker
1x mounting part
1x spacer washer
1x side stand, short
Fork preparatory work
- Remove the front fender (see repair manual).
- Raise the motorcycle with a lift stand (see repair manual).
- Remove the fork legs (see repair manual).
Disassembling the fork legs
NOTE
The operations are the same on both fork legs.
- Clamp the fork leg in the area of the upper triple clamp (distance
= 25 mm) in a bench vise.
Clamping block T612S
- Loosen screw cap
.
NOTE
The screw cap cannot be removed yet.
- Unclamp the fork.
- Drain the fork oil.
- Clamp the fork leg with the fork shoe in the bench vise.
NOTE
Use soft jaws.
- Remove cartridge screw
NOTE
Place a container underneath as oil will run out in most cases.
with the washer.
9
Publicidad
