To Do A Check Of The Chain Catcher; To Do A Check Of The Power Trigger Lockout; To Do A Check Of The Functions Of The User Interface; To Do A Check Of The Battery And The Battery Holder - Husqvarna 340i Manual Del Usuario

2. Wrap your fingers and thumbs around the handles
and hold the product tight.
3. Apply full power and tilt your left wrist against the
front hand guard to engage the chain brake. The
saw chain must stop immediately.
WARNING: Do not let go of the front handle!

To do a check of the power trigger lockout

1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring
operates correctly.
2. Push the power trigger lockout forward (A) and down
(B). Hold the power trigger lockout against the
handle and make sure that it goes back to its initial
position when you release it.
B
A
26
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary.
WARNING: If the saw chain rotates
when the power trigger is in the idle
position, speak to your servicing dealer.

To do a check of the chain catcher

1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the functions of the user
interface
1. Start the product. Refer to
2. Set the power lever to the stop position.
3. Make sure that the power trigger is locked.
To do a check of the battery and the
battery holder
1. Clean the battery and the battery holder with a soft
brush.
Operation on page 14 .
1155 - 002 - 13.05.2020