Publicidad
Idiomas disponibles
Idiomas disponibles
4. Connect the coupler of Grip
Heater (R) D to the coupler
(Orange/Yellow
Black) of Grip Heater Lead Wire
A.
5. Connect the coupler of Grip
Heater (L) E to the coupler
(Orange/Yellow and Orange) of
Grip Heater Lead Wire A.
6. Connect the coupler of Grip
Heater Switch B to the coupler
of Grip Heater Lead Wire A.
7. Clamp the Grip Heater Lead
Wire A and brake pipe with
Clamp F.
Install Grip Heater (R) D.
1. Loosen the screw of balancer
with a + driver several turns
and pull the balancer assembly
out of the handlebars.
NOTE: Loosen the screw only
enough to remove the bal-
ancer. Otherwise, the bal-
ancer may disassemble
and
some
may remain in the handle-
bar.
2. Remove the two screws of the
switch box. Loosen the throttle
pulling cable and disconnect
throttle cables carefully from
the right grip. Pull out the right
grip from the handlebars.
NOTE: Do not force to remove the
throttle cables when dis-
connecting
cables.
and
White/
components
Screw
the
throttle
GENUINE SUZUKI ACCESSORIES
12/20
Balancer
Balancer
Balancer
Screw
Screw
Screw
Throtlle pulling cable
Publicidad
