Set two Clamps F.
1. Pass the Grip Heater (R) D
lead wire between the brake
lever holder and switch box.
Match holder joint section and
white tape point. Clamp F the
Grip Heater (R) D lead wire at
the white taping point.
2. Clamp the Grip Heater (R) D
lead wire, right switch box lead
wire and brake hose with
Clamp F.
NOTE: Cut off the excess clamp.
3. Re-clamp the Grip Heater (R)
D lead wire and switch box
lead wires (RH) with guide
plate.
4. Re-clamp the Grip Heater (L) E
lead wire, Grip Heater Switch B
lead wire, left switch box lead
wire and clutch cable with clamp
and Clamp F.
Guide plate
Guide plate
Guide plate
GENUINE SUZUKI ACCESSORIES
17/20
White taping point
White taping point
White taping point
Clamp
Clamp
Clamp
Clamp
Clamp
Clamp