To Stop The Product; Pull Stroke And Push Stroke; To Use The Cutting Technique - Husqvarna 439 Manual Del Usuario

starter rope handle. This can cause
damage to the product.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note You can identify when the engine fires
through a "puff" sound.
b) Disengage the choke.
6. Pull the starter rope handle until the engine starts.
7. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
8. Move the front hand guard rearward to disengage
the chain brake.
9. Use the product.

To stop the product

1. Push the start/stop switch down to stop the engine.

Pull stroke and push stroke

You can cut through wood with the product in 2 different
positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
the tree when you cut. In this position you have
14
better control of the product and the position of the
kickback zone.
• To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING If the saw chain is caught in
the trunk, the product can be pushed at
you. Hold the product tightly and make
sure that the kickback zone of the guide
bar does not touch the tree and causes a
kickback.

To use the cutting technique

WARNING Use full throttle when you cut
and decrease to idle speed after each cut.
CAUTION Engine damage can occur if the
engine runs for too long at full throttle
without load.
823 - 006 - 18.09.2019