Troubleshooting - Steamfast SF-210 Guia Del Propietario

PROBLEM
Unit fails to heat up. Heating
Indicator Light DOES NOT illuminate.
Unit fails to heat up. Heating
Indicator Light DOES illuminate.
NOTE: Always allow sufficient
time for unit to heat up before
pressing Steam Trigger.
Steam output is weak or intermittent.
Boiler Cap cannot be unscrewed.
12 | ENGLISH

Troubleshooting

POSSIBLE CAUSE
Unit is not plugged in.
Household circuit breaker / ground
fault interrupter has tripped or blown
a fuse.
Unit is damaged or otherwise in
need of repair.
No water in Boiler.
Mineral build-up in unit.
Unit is damaged or otherwise in
need of repair.
Water level in Boiler is running low.
Mineral build-up in unit.
Boiler Cap has been overtightened
after previous use.
SOLUTION
Plug power cord into electrical outlet.
Reset circuit breaker / ground fault
interrupter, or replace fuse. For
assistance, contact a licensed electrician.
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see Page 13 for details).
Refer to Filling Boiler procedure on
Page 9 to fill unit with water.
Refer to Care & Maintenance
section on Page 11 for details.
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see Page 13 for details).
Refer to Refilling Boiler procedure
on Page 9 to refill unit with water.
Refer to Care & Maintenance
section on Page 11 for details.
Boiler Cap should always be replaced
loosely when storing. For assistance
with a Cap that has become stuck,
contact Consumer Service (see Page
13 for details).