Steamfast SF-210 Guia Del Propietario página 7

CONNECTING BRUSHES
NOTE: The Nylon Utility Brush, Brass Utility Brush and Large Brush are all attached in the
same manner. The Nylon Utility Brush is illustrated in FIGURE 3 as an example.
1. Align Brush with Jet Nozzle as shown. Guide key on back of Brush should line up with key
slot on side of Jet Nozzle tip (FIGURE 3-A).
2. Firmly press Brush onto Jet Nozzle (FIGURE 3-B).
CAUTION: Make sure Brush is pushed as far as possible onto tip to ensure that it is
seated securely. This will prevent steam leaks and ensure that Brush is not forced off of
Jet Nozzle by steam pressure.
3-A
GUIDE KEY
KEY SLOT
FIGURE 3
3-B
ENGLISH | 7