American Standard AM4242N3400C Serie Instrucciones De Instalación página 6

3
ASSEMBLING DOOR PANEL TO THE WALL
NOTE: TWO PEOPLE REQUIRED
1. Place the Shims [23] on the Aluminum Seal as shown in 1a. Place the Fixed Panel [4] on the Aluminum Seal as shown in 1b.
2. With the Fixed Panel leveled, mark the locations of the holes in the Wall Brackets on the wall.
3. Remove the Fixed Panel and drill 1/8" (3 mm) holes where marked (Note – if not using the Axis Shower Wall 4242CW drill
a 1/4" (6 mm) hole for the Wall Anchors which must be used).
4. Replace the Fixed Panel and secure the Wall Brackets to the wall using the M5x50 Screws [2].
Be sure that the Fixed Panel is level and plumb before fully tightening the
screws. Place Screw Cover Caps [26] over the screw heads as shown in 4b.
5. Install the Bumpers [11] on the Aluminum Seal using the M4x12 Screws [10].
Place Screw Cover Caps [6] over the screw heads.
6. Repeat steps 1 thru 5 for the second Fixed Panel.
2
3
4
5
1
NOTE: The above illustrations show the door assembled with the handle on the right side. If the door is to
be assembled so the handle is on the left side, the xed panels are to be reversed as shown below.
A
5
1
B
6
1a
2
4a
Screw M5x50
5
Screw M4x12
A
B
1b
3
4b
7103 5 4 - 10 0 Rev. A 8 /16