American Standard AM4242N3400C Serie Instrucciones De Instalación página 8

6
ATTACHING THE SUPPORT BARS
1a. Put two Cushions [17] in the open end of the Support Bar [18] and slide it onto the top of the Fixed Panel.
1b. Place the Support Bar against the wall and mark the locations of the holes.
1c. Drill 1/8" holes where marked.
Note - if not using the Axis Shower Wall 4242CW drill a 1/4" hole for the Wall Anchors which must be used.
2a. Insert Wall Anchors if needed and secure the Support Bar to the wall using the M4 x 35 Brad Screws [19].
2b. Attach the Screw Cover Caps [25].
2c. Tighten the screws on the Support Bar as shown.
Repeat all steps (1 - 2) for second bar.
7
APPLYING SILICONE
1. Apply silicone as shown.
1a
1b
1c
NOTE: ALLOW
24 HOURS FOR
SILICONE TO DRY
BEFORE USE.
8
2a
Brad Screw
M4x35
2b
2c
7 10 35 4 - 10 0 Rev. A 8 /16