Setting Up And Making A Aluminum Weld - Lincoln Electric 180 Serie Manual Del Operador

WIRE FEEDER WELDER (180 MODEL)
SETTING UP AND MAKING A ALUMINUM WELD USING SPOOL GUN
1. Loosen the THUMB SCREW Disconnect Magnum 100L Gun.
2. Insert K2532-1 Magnum 100SG spool gun into the brass block
and tighten the THUMB SCREW.
3. Depress Gun selector SWITCH to Spool Gun position. (See
Figure B.20 and B.21)
4. Connect a bottle of 100% Argon shielding Gas per previous
section.
5. Follow the MIG welding steps in the previous section.
FIGURE B.20
6. Turn machine on and make weld per recommended settings
on Procedure Decal inside machine door. The settings listed
on the procedure decal are suggestions. The dials may need
to be adjusted to accommodate the application, input voltage
or user preference.
(Location of Selector Switch and Thumb Screw)
SWITCH
THUMB SCREW FOR
CONNECTING THE
MAGNUM 100L GUN OR
MAGNUM 100SG SPOOL GUN.
B 11
OPERATION
FIGURE B.21
MAGNUM 100SG MAGNUM 100L