Iso Ddin Radio Provision - Metra 95-6511 Manual Del Usuario

ISO DDIN radio provision

1. Depending on the style of radio to be
installed, secure either the "A" "Long
nose" (wide) DDIN trim panels, or "B"
"Short nose" (narrow) DDIN trim panels,
to the ISO DDIN radio brackets using
(4) #8 x 1/4" Phillips screws provided.
(Figure A)
Note: The trim panels are stamped on
the back indicating the top and which
style of radio the trim panel should be
used for. "A" for long nose radios,
"B" for short nose radios.
2. Secure the completed bracket assembly
to the radio using the screws supplied
with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
unit for proper operation.
4. Reassemble the dash in reverse order
of disassembly.
KIT ASSEMBLY
"A" trim panel assembly
(Figure A)
(Figure B)
"B" trim panel assembly
15
REV. 12/12/2017 INST-6511