Suzuki 99000-99008-100 Instrucciones De Instalación página 7

4. Connect the Earth Wire H to
the "GND" terminal of the IC
Relay F.
5. Connect the Earth Wire H to
(−) terminal of the Battery.
6. Install the IC Relay F into the
position where the standard
Relay was installed.
Installation of front LED turnsignal
(Do the same operation for right
and left side)
1. Remove the standard Front
turnsignal.
(Refer to the DL1000A service
manual)
2. Install the Bracket C, standard
plate which were removed in
step (1), Washer E, and Nut D
into the LED Turnsignal A.
Connect the Lead Wire B to
the LED Turnsignal A.
IC Relay IC Relay
Bracket Bracket
LED Turnsignal LED Turnsignal
Lead Wire Lead Wire
GENUINE SUZUKI ACCESSORIES
Earth Wire Earth Wire ---> "GND" ---> "GND"
Battery (−) terminal Battery (−) terminal
Standard plate Standard plate
Washer Washer
Nut Nut
7/10