Safety Conditions - Festo DSMI-B Serie Instrucciones De Utilizacion

DSMI−...−B
4

Safety conditions

For electronically closed−loop control of the DSMI in combination with a
positioning controller:
Note
Special conditions apply to the electronic regulation of the DSMI.
· Note the warnings and instructions in the descriptions of the positioning
controller.
The following applies to all applications:
Note
Malfunctions will occur if the device is not used correctly.
· Make sure that the specifications in this chapter are always observed.
· Compare the limit values specified in these operating instructions with your
actual application (e.g. pressures, forces, torques, temperatures, masses).
The product can only be operated in accordance with the relevant safety
guidelines if the maximum load limits are observed.
· Take the ambient conditions at the location of use into account.
Corrosive environments (e.g. ozone) will reduce the service life of the product.
· Make sure that the compressed air is properly prepared (è Technical data).
· Maintain the selected medium for the complete service life of the product.
Example: Always use non−lubricated compressed air.
· Pressurise your entire system slowly. There will then be no uncontrolled
movements.
For slow start−up pressurisation, use the HEL pressure build−up.
· Please comply with national and local safety laws and regulations.
· Remove all transport packaging such as foils, caps and cartons
(except for any plugs in the pneumatic connections).
The packaging is intended for recycling on the basis of its constituent
materials (exception: oiled paper = other waste).
26
Festo DSMI−...−B 1003a English