Sauder 401354 Manual De Instrucciones página 12

Step 7
Fasten three ANGLE BRACKETS (OO) to the LEFT END (B).
å
Use three GOLD 9/16" LARGE HEAD SCREWS (III).
NOTE: The ANGLE BRACKETS should not be even with the
å
edges of the LEFT END. The DESK MOLDING will rest on
the edge of the LEFT END.
Fasten the DESK MOLDING (Z) to the LEFT END (B). Use
å
three GOLD 9/16" LARGE HEAD SCREWS (III) through the
ANGLE BRACKETS and into the DESK MOLDING.
NOTE: There are no pre-drilled holes in the MOLDING (Z).
å
The SCREWS will tighten into the groove.
OO
Page 12
(3 used)
Z
GOLD 9/16" LARGE HEAD SCREW
B
These edges
should be even.
401354
III
(6 used in this step)
www.sauder.com/services