Black 1-9/16" Flat Head Screw - Sauder 401354 Manual De Instrucciones

Step 23
1
D87
R
Groove
Insert the DRAWER SIDES (D87 and D88) at an angle
å
into the slot at each end of the DRAWER FRONT (R).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D87
å
and D88). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the
å
groove of the DRAWER BACK (D78).
Repeat this step for the other drawer.
å
Page 28
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
D88
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
r f a
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D708) into the grooves in the
å
DRAWER SIDES (D87 and D88) and DRAWER FRONT (R).
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

(8 used in this step)
401354
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
e d
c e
D708
D88
R
30S
www.sauder.com/services