Sauder 401354 Manual De Instrucciones página 16

Step 11
Insert four METAL PINS (ZZ) into the ends of the LONG DIVIDERS (V).
å
Push the METAL PINS (ZZ) in the ends of the LONG DIVIDERS (V) into
å
the holes in the HUTCH TOP (I).
Insert four METAL PINS (ZZ) into the ends of the SHORT SHELF (L).
å
Push the METAL PINS (ZZ) in one end of the SHORT SHELF (L) into
å
the holes in the HUTCH UPRIGHT (G).
NOTE: Be sure the hole in the SHORT SHELF measures 7-5/8" from
å
the HUTCH UPRIGHT as shown in the diagram.
Fasten the SHORT SHELF (L) to the LONG DIVIDERS (V). Use two
å
BROWN 1-1/2" FLAT HEAD SCREWS (DDD).
Page 16
L
G
7-5/8"
BROWN 1-1/2" FLAT HEAD SCREW
(2 used in this step)
401354
Finished edge
V
V
I
ZZ
DDD
www.sauder.com/services
ZZ
(8 used)