Grease Filter Removal, Mounting The Activated Charcoal Filter; Electrical Connection Of The Hood - Sirius S-DD16 ESSENCE Instrucciones Para El Uso Y De Montaje

HOW TO USE THE COOKER HOOD
This appliance is intended to suck cooking fumes,
greases and steam. It has been designed to work
in both suctioning mode, with outside evacuation,
and filtering mode.
Outside - discharge version
The cooker hood can be mounted in the version
with outside discharge of suctioned air: in this case
it is necessary to connect the exhausting channel
to the outside (exhausting pipes are not supplied
with the products.)
Filtering mode
In case fumes and vapour cannot be evacuated
outside, the appliance can be used in the filtering
mode.
Activated charcoal filters are required for this type
of cooker hood.
Air recycled conveyed outside furniture.
CAUTION
Installation must comply with the regulations
in force regarding the ventilation of enclosed
environments. The use of discontinued ducts
is not allowed without the approval of a quali-
fied technician.
REMOVAL OF GREASE FILTER, MOUNTING
THE CARBON FILTER
The assembly and disassembly of grease filters
and carbon filters must be made with the down-
draft in the open position. For this, actuate the
opening of the glass as indicated by the operation
section.
Inhere the grease filters as shown in figure 7, in the
case the carbon filters are necessary, first install
the grease filter as shown in figure 7.
WARNING
After having replaced the filters, reinstall the
front stainless steel pan'el, otherwise the
Downdraft is not enabled to function.
ESSENCE - JOLLY
EN
ELECTRICAL CONNECTION
OF THE COOKER HOOD
WARNING
Place the metal box containing the electronic
components at a distance of no less than 65
cm from cook tops or in any case, 65 cm from
the suctioning surface of the cookerhood.
We recommend installing the metal box con-
taining the electronic components at least 10
cm above floor level and at a suitable distan-
ce from all heat sources (e.g. oven sides or
cook top).
CAUTION
This appliance is fitted with an H05 VVF 3 con-
ductor, 0.75 mm2 (neutral, phase, and ground)
power cord.
This can be connected up to a 220 - 240 V
mono-phase electrical network through a CEI
60083 approved power socket, which must
remain accessible after installation, in com-
pliance with installation regulations.
We decline any responsibility in case of ac-
cidents caused by a lack of ground connec-
tion or incorrect ground connection. The
appliance must be fed through a differential
protection device (RCD), with a nominal resi-
dual current not exceeding 30mA. If the power
cord is damaged, call the after-sales service
to avoid any risk.
NOTA
17