Calibrating Valve Position; Configuring Your System - Akron Brass Navigator Pro Instrucciones De Instalación, Funcionamiento Y Mantenimiento

6.1 CALIBRATING VALVE POSITION

Menu location: Setup Menu → OEM Configuration → Valve Setup → Valve Calibration
The valve must be calibrated to ensure the position of the valve is accurate. Navigate to the Valve Calibration screen (for details on accessing this screen
and navigating the menu, see the "SETUP MENU NAVIGATION" section below). The screen will display the following warning: "The valve will fully open
and close during calibration ." After you have verified that the valve is properly installed to the motor, and there is no danger of damage due to water in
the line, press
■ START to begin the calibration process .
The valve will fully open and close twice to calibrate the valve position sensor . After calibration is complete, press the
■ OK button to return to the Valve Setup screen .

7 CONFIGURING YOUR SYSTEM

MENU NAVIGATION
The Setup Menu provides access to all of the Navigator Pro's settings, options, and calibration procedures . The menu options are as follows:
• Display
o Auto Dim
o LCD Brightness
o Numeric Position on Graph
• Presets
o Number of Presets
o Preset Positions
• Diagnostics
• OEM Configuration
o Valve Setup
• Valve Assignment
• Valve Name
• Valve Name
• Valve Number
• Valve Color
• Valve Calibration
• Valve Options
• Auto Open
• Use Factory Defaults
o Valve Download
To access the Setup Menu during normal operation, press and hold the ■ MENU button for 5 seconds . The button label will blink with the text "MENU"
while the button is being held to indicate that the Setup Menu is being requested . When the label stops blinking, release the button and the Setup Menu
will be displayed . Alternatively, the
GREEN buttons can both be held down at the same time for 15 seconds and this will access the Setup Menu . NOTE: The OEM Configuration option
will only be displayed when the Setup Menu is accessed by holding the
GREEN buttons . If the ■ MENU button is used to access the menu, the OEM Configuration option will not be shown .
Throughout all of the setup and options menus, the
or decrease a highlighted value . The three buttons below the screen will have on-screen labels to identify their function . For example, pressing the ■
ENTER button will enter the highlighted menu screen . Pressing the ■ DONE button will return to the previous menu . These labels will change
depending on which menu screen is active .
RED and
RED and
RED and
GREEN buttons can be used to move to a different menu choice, or to increase
Page 09