Presets - Akron Brass Navigator Pro Instrucciones De Instalación, Funcionamiento Y Mantenimiento

7.2

Presets

Menu location: Setup Menu → Presets
The Style 9323 Navigator Pro is capable of storing up to three valve positions . These are referred to as "Presets" . Once stored, the user can quickly
revert the valve back to a saved position from the main screen . There are two ways to set the preset valve positions . They can be set either on the main
operation screen or in the Presets Menu . The menu options are as follows:
• Number of Presets
• Preset valve positions
Number of Presets: The Navigator Pro system can be set to have 0, 1, 2 or 3 presets active . To adjust the number of presets, follow these steps:
1 . Navigate to the Presets menu
RED or
2 . Use the
3 . Press the ■ SET button to save the value .
Preset Valve Positions: The preset valve positions can be set in 5 percent increments from 0% to 100% . These positions can be set on the main opera-
tional screen or in the Presets Menu . To store the preset valve positions, follow one of the following setup procedures:
To set from the Presets Menu:
1 . Navigate to the Presets Menu
2 . Press the ■ NEXT button so the value under "P1" is highlighted
RED or
3 . Use the
4 . Press the ■ SET button to save the value
5 . Repeat steps 3-4 to set the remaining preset positions, or press the ■ NEXT button to skip to the next value .
To set from the main screen during normal operation:
1 . Adjust the valve to the desired position
2 . Press the ■ PRESET button until the desired preset is highlighted
3 . Press and hold the ■ NEXT button until its label changes to "SET" and blinks for 5 seconds . When it stops
blinking, release the button and the new preset position is saved .
4 . Repeat steps 1-3 to set other active presets .
After the desired presets are configured, the operator can easily send the valve to a preset position during normal operation . Simply press the ■ PRE-
SET button until the desired preset is highlighted, and then press the ■ ■ GOTO button .
GREEN button to select the desired number of presets
GREEN button to set the desired valve position for the first preset
Page 11