Back-To-Back Installation; Installation Instructions - American Standard VorMax Plus 708AA Serie Manual Del Propietário

CAUTION
:
IF A VORMAX PLUS FRESHINFUSER IS NOT SECURELY INSERTED INTO THE SPUD OPENING,
!
NOT FLUSH THE TOILET
VORMAX PLUS FRESHINFUSER INSERTED IN THE SPUD OPENING AT ALL TIMES WHEN FLUSHING THE TOILET.
For further assistance please call Customer Care at: (800) 442-1902

Installation Instructions:

Recommended fitting type for
back-to-back installations.
Install T-Bolts onto the flange
and screw the retaining nuts
to hold into place.
Align the bowl and bolt
holes to set into place.
Apply weight evenly.
Do not move after
placement as water
tight seal may break.
TIP: Place a piece of masking
tape on the floor next to the
bolts on both sides to help
with alignment.
4
pg
AS THIS MAY RESULT IN WATER LEAKING FROM THE TOILET. TOILET MUST HAVE A

BACK-TO-BACK INSTALLATION

1
3
Depending upon your plumbing and venting conditions, the flow from
this toilet in a back-to-back installation may create a vacuum on the
system and draw water from the opposing bowl. The National
Standards Plumbing Code prohibits the use of a cross fitting for
drainage as throw over is possible. The code does approve a
directional "Y" style fitting with proper venting to direct the water
downward and away from the other toilet.
Flip the bowl upside down and press the wax ring down firmly.
!
Hand tighten only.
Do not overtighten.
BOLT CAP
BOWL-TO-FLOOR
KNOBS
2
4
DO