Installing The Mounting Plate; Installing The Batteries - Defiant DFI-7148-BK Guía De Uso Y Cuidado

Installation (continued)
4

Installing the mounting plate

NOTE: Make sure there is enough vertical space above
the mounting plate to allow the light fixture to be mounted.
□
Place the mounting plate (D) against the
mounting surface and ensure the mounting
plate (D) is level. Mark the hole locations.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the mounting plate (D) and into
the mounting surface.
5
Removing the battery cover
□
Press up on the battery compartment cover (3)
locking tab (4) and swing the cover (3) out and
down to remove.
6
Connecting the solar battery
This light fixture (B) is shipped with the internal,
rechargeable, Li-ion battery disconnected from the
light (B).
□
Gently press down on the wiring harness (5) as
shown by arrow 1.
□
Slide the mail connector into the female
connector as shown in arrow 2.
7

Installing the batteries

IMPORTANT: The "C" batteries (6) are used when the rechargeable
solar battery is depleted. When the "C" batteries (6) are depleted,
a red LED (7) will flash inside the motion sensor (C) and the "C"
batteries (6) will need to be replaced.
□
Install three, 1.5V "C" batteries (6 - not
included) into the battery compartment. Make
sure the polarity of the batteries is correct.
□
Replace the battery compartment cover (3).
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
mounting plate (D) using the two mounting
screws (AA).
AA
3
4
IMPORTANT: Once the the solar battery harness is connected,
there will be no need to touch this harness again.
2
1
5
6
7
Please contact 1-866-308-3976 for further assistance.
D
2
B
1
7
C
HOMEDEPOT.COM
W