Operation - Defiant DFI-7148-BK Guía De Uso Y Cuidado

Operation

1
Adjusting the lamp heads
□
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
A
3
Determining the motion sensor
detection zone
NOTE: The motion sensor (C) is non-adjustable. It has a
sensing angle of 180° and a range of approximately 40 ft.
depending on the surrounding temperature.
NOTE: When the control dial (E) is set to the "TEST"
position, the light (B) will operate during the day or night.
The light (B) will stay on for 5 seconds after all motion is
stopped.
NOTE: The motion sensor (C) will need to completely
warm up (60 seconds) before beginning the setup process.
□
Turn the control dial (E) to the TEST position.
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light (B). The light (B) will come on
indicating motion has been detected.
□
Stop, wait for the light (B) to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
W
2
Using the OFF control
□
Turn the control dial (E) to the OFF position
to turn the light (B) off and to conserve the
battery life.
B
W
B
W
C
9
Please contact 1-866-308-3976 for further assistance.
E
E
HOMEDEPOT.COM