Be Cool LIGHT Manual Del Usuario página 15

1
Follow the 1 arrow direction to open the latch. Then follow the 2 arrow direction to lift and
flung the stroller to open it.
2
See picture 2, this is how it fully open.
3
Follow the arrow direction to plug the wheel bearing into the wheel housing.
4
See jig A, follow the arrow direction to plug the rear wheel into wheel housing, and finish
rear wheel assemble. See jig B, press the rear wheel detach button and pull the wheel out in
order to detach the rear wheel.
5
See picture 5, follow the arrow direction to press the brake button to brake the stroller.
6
See picture 6, lift the brake button to release the brake.
7
See picture 7, pull the button up as the 1 arrow direction to lock the swivel wheel. To push
down as 2 arrow direction to release the swivel wheel.
8
See pictures 8, as the picture shows, plug the front bumper bar both side into the hole to
assemble the front bumper bar.
9
See picture 9, Right-hand follow 1 arrow direction to lift outward, Left-hand pull the front
bumper bar out follow 2 arrow direction to detach the front bumper bar.
10a
If it is two position back rest, adjust the backrest position as 10a picture.
10b
If it is multiply backrest position, adjust the backrest position as 10b picture. Lefthand
squeeze and press the button,and righthand full the D ring to adjust the backrest position.
11
See picture 11, follow 1 arrow direction to move the canopy forward or backward.
12
LOCKING THE FOOTREST
13
Lift the folding latch follow the 2 arrow direction can fold the handle bar, see how it is as picture
13.
14
See picture 14, Right-hand forefinger press the red second lock button, the rest three fingers
lift the folding button follow 2 arrow direction. Meanwhile, follow 3 arrow direction to pull
back to fold the stroller.
15
See picture 15, follow arrow direction to snap the lock to lock the stroller. Release the lock
to open stroller.
16
See picture, once lock the stroller, you can carry the stroller like the picture.
17
ADJUST THE SEAT BELTS TO FIT THE CHILDREN WHENEVER THEY USE THE PUSHCHAIR.
The two side fastening points of the seats can be used to at-tach an additional harness.
Your pushchair is approved for new born babies. To fit the belts on your baby when he is
under 6 months old, pass the shoulder straps through the lower holes and fasten the shoul-
der protector pads using the Velcro. When your child is over 6 months old, pass the straps
through the holes that are most comfortable for the child.
IM 1844 ,01 LIGHT ins 17_2_16.indd 15
GB
15
23/02/16 17:14