Operation With Mfx - marklin 76495 Manual De Instrucciones

Sample of the correct address assignment for MM:
Adress 5
Sample of the correct address assignment for DCC:
The address for the distant signal (CV55 / CV56) and the signal
type (CV46) must correspond to the address and the signal type
for the home signal following it. This is the only way to guarantee
the correct reproduction of the signal aspect.
Adress 5
Adress 6
Signal type is recognized
automatically
Adress 3
Signal Type:
Block Signal

Operation with mfx

mfx registration can be done with MM or DCC.The mode of ope-
ration that has been set by means of Dip Switch 10 is critical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in > and with the 60216/60226 CS3 in the solenoid item
configuration by means of
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item" at
„Setup" > > „Track".
If the check mark there is checked, the mfx registration is done
at the first open address in the CS2. If the check mark is not
checked, the mfx registration is done at the address actually
programmed on the decoder.
>"search for mfx item".
13