Listening To The Radio - JVC CA-MXJD5 Manual De Instrucciones

Listening to the Radio

To select the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing.
You can change the AM tuner intervals during the unit is
turned on.
While AM is selected...
(holding then...)
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
1
sec.
Increases the frequencies.
Decreases the frequencies.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
To stop searching manually, press either button.
• When you repeatedly press the button, the frequency
changes step by step.
If the received FM station is hard to listen
(holding then...)
INFO
AM 9 k
AM 10 k
FM AM
Remote
ONLY
The MONO indicator
lights on the display.
Reception will improve
though stereo effect is
lost—monaural
reception mode.
To restore the stereo
effect, press the button
again (the MONO
indicator goes off).
Main Unit
ONLY
To preset Stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset, then enter into
the presetting mode.
SET
/ DISPLAY
2
Select a preset number for the station you store.
PRESET
3
Store the station.
SET
/ DISPLAY
To turn in to a Preset Station
1
Select the band (FM or AM).
2
Select a preset number for the station you store.
Examples:
To select preset number 5, press 5.
To select preset number 15, press
+10, then 5.
To select preset number 30, press
+10, +10, then 10.
• You can also use 4/¢
buttons on the remote control or
the PRESET +/– buttons on the
main unit.
ST
ST
ST
FM AM
15