Publicidad
FIG. 4
4) Attach the facing assembly to the Side Panels (C) with 3/4" Cam Housings (S). Make sure that the
bottom stamped edges of the Facings are toward the Bottom (BB).
FIG. 5A
5) Carefully lay the unit face down on a protected surface. To square the unit, measure from top left to
bottom right and from top right to bottom left. The measurements should be equal. If one is longer,
tap the bottom of the side panel on the longer side until equal. Attach the Back (D), flush with the
bottom and centered side to side, with #6x5/8" Philtruss Screws (X).
NN
M
FIG. 6
6) Insert two 5mm Dowels (ZL) into appropriate holes in each Apron (L, M, & NN). Be careful not to
glue dowels into the screw holes.
S
S
S
S
C
ZL
ZL
ZL
ZL
S
S
S
S
BB
X
FIG. 5B
ZL
X
D
X
X
ZL
L
ZL
ZL
L
X
276W — PAGE 5
Publicidad
