Publicidad
ZM
ZN
FIG. 12
12) Attach a Double Magnetic Catch (ZM) to the Catch Spacer (ZN) using the screws, contained in
the kit, in the prepunched holes in the spacer. See FIGURE 12. Center the Catch Spacer (ZN)
behind the upper Sleeper (I) so that only the double magnetic catch is showing. Attach the spacer
to the sleeper with #7 x 1½" Black Pan Head Screws (ZI) through the predrilled holes in the spacer.
See FIGURE 12A.
Repeat process with a second Double Magnetic Catch (ZM) on the lower Sleeper (I). See
FIGURE 12B.
E
E
FIG. 13
13) Install Shelf Brackets (Y) at desired levels for Adjustable Shelves (E). Insert shelves on brackets
and fasten in place with #6x1/2" Undercut Screws (ZZ) through the brackets into the bottom of the
shelves.
Attach catch plate to the upper and lower corners of each door where they will make contact with
the magnetic catch. Use the screws provided in the kit. See FIGURE 13B.
Attach Knobs (ZE) and Backing Plates (ZF) to doors with #8 x 1¼" Machine Screws (ZJ) through
the predrilled holes. Tap Brad (ZP) into the hole in each Backing Plate (ZF). See FIGURE 13C.
14) When you have determined the location for your unit, install the Furniture Tipping Restraint (ZO).
Carefully follow the instructions on the package.
PAGE 8 — 276W
ZN/ZM
ZI
FIG. 12A
ZZ
FIG. 13A
FIG. 13B
I
Y
ZI
ZN/ZM
I
FIG. 12B
ZJ
ZE
ZF
ZP
FIG. 13C
Publicidad
