Sauder 420645 Manual De Instrucciones página 6

Step 2
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the enlarged diagram
å
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the RIGHT END (A) and UPRIGHT (C). Use twelve BLACK 1/2" PAN
å
HEAD SCREWS (18).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
å
the inner cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the END
and UPRIGHT. Turn a SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
2
Push the black lever up and
pull the SLIDE from the RAIL.
1
Open end
Page 6
Open end
BLACK 1/2" PAN HEAD SCREW
(12 used in this step)
This HIDDEN CAM
must be here.
C
1
www.sauder.com
1
Use these holes.
18
1
A
These holes are
closer to this edge.
Open end
1
420645