Saivod LST1261 Manual Del Usuario página 14

Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush. If the filters are too dirty, take them out
by means of pliers and clean them. Take out the
filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly
under running water. Replace the gaskets and
filters carefully in their places and tighten the hose
nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(eg., when moving to another house) and in case
of freezing of the water, water may have to be
drained completely.
Foreign substances left in the pump filter may
A
damage your machine or may cause noise
problem.
In order to clean the dirty filter and discharge the
water:
Unplug the machine to cut off the supply power.
Temperature of the water inside the machine
A
may rise up to 90 ºC. To avoid burning risk,
filter must be cleaned after the water in the
machine cools down.
Open the filter cap.
If the filter cap is composed of two pieces,
press the tab on the filter cap downwards and
pull the piece out towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
You can remove the filter cover by slightly
C
pushing downwards with a thin plastic tipped
tool, through the gap above the filter cover.
Do not use metal tipped tools to remove the
cover.
Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
Pull the emergency draining hose out from its seat
Place a large container at the end of the hose.
Drain the water into the container by pulling out the
plug at the end of the hose. When the container
is full, block the inlet of the hose by replacing the
plug. After the container is emptied, repeat the
above procedure to drain the water in the machine
completely. When draining of water is finished,
close the end by the plug again and fix the hose in
its place. Turn the pump filter to take it out.
Discharging the water when the product does not
have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed
in front of the filter. Always keep a piece of cloth
handy to absorb any spilled water. When the water
inside the machine is finished, take out the filter
completely by turning it. Clean any residues inside
the filter as well as fibers, if any, around the pump
impeller region. Install the filter.
If your product has a water jet feature, be
A
sure to fit the filter into its housing in the
pump. Never force the filter while installing it
into its housing. Seat the filter into its place
completely. Otherwise, water may leak from
the filter cap.
If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to close.
14
EN